Usethe ÷ button to select[OK]and
pressthe FUNC./SET button.
* To perform
a low level format,
use the
button to select [Low Level Format] and
the ÷
or €_ button to add a check mark.
To exit instead of formatting,
select
[Cancel].
If [Low Level Format]
is selected, you can
stop formatting
partway by pressing the
FUNC./SET button. You can still use the
SD card without problem
even if
formatting
was halted partway.
The capacity of the SD card displayed
after
formatting
will be less than the rated
capacity of the SD card. This is not a
malfunction
of the SD card or camera.
_""_e'_'i""F_'_'_"at
_'_'_¸'¸
..........................................................................................................................
You should select the [Low Level Format] option if you suspect the
read/write
speed of an SD card has dropped
or if you wish to
completely
erase its data. A low level format may require 2 to 3
minutes with some SD cards.
• When the camera is malfunctioning,
a corrupted
SD card might be
the cause. Reformatting
the SD card may solve the problem.
• When a non-Canon
brand SD card is malfunctioning,
reformatting
it
may solve the problem.
• SD cards formatted
in other cameras,
computers,
or peripheral
devices
may not operate correctly
in this camera.
When that
happens,
reformat the SD card with this camera.
If formatting
in the
camera does not work properly, turn the camera off and re-insert the
SD card. Then turn the camera back on and format again.
26