Adjusting The Tear-Off Position - Epson 5000/5500 User Manual

Tear Off

Adjusting the tear-off position

If the perforation is not aligned with the tear-off edge, adjust the
tear-off position by following the steps below:
Make sure the paper is in the tear-off position and the
1.
light is on.
While holding down the
2.
button to adjust the tear-off position to a lower position on the
page or press the
higher position on the page. The printer remembers the new
tear-off position.
Tear off any printed pages.
3.
4. When you begin printing, the printer automatically feeds the
paper back to the loading position and begins printing. (You can
also manually feed the paper back to the loading position by
pressing the
Note:
The printer has a minimum and maximum tear-off position. If
l
you try to advance the loading position beyond these limits,
the printer beeps and the paper stops moving.
When the paper reaches the factory-set tear-off position, the
l
printer beeps and paper feeding pauses briefly. Use the factory
setting as a reference point when adjusting the tear-off
position.
3-18 Using the Printer
ALT
LF/FF
button to adjust the tear-off position to a
LOAD/EJECT
or
button, press the
TEAR OFF
button.)
TEAR OFF
LOAD/EJECT