Micro Feed
Adjusting the loading position
The loading position is the position of the paper after it has been
automatically loaded by the printer. If printing is too high or low
on the page, change the loading position with the micro-feed feature
as follows:
1. Make sure the printer is turned on.
2. Load either continuous or single-sheet paper. (Load continuous
paper by pressing the
begins to blink.
Note: You can adjust the loading position only while the
PART
light is blinking.
3. While holding down the
button to adjust the loading position to a lower position on the
page; press
higher position on
after a short time.
3-14
Using the Printer
LOAD/EJECT
ALT
the LF/FF
button to adjust the loading position to
the
page. The
button.) The
button, press the
MULTI-PART
MULTI-PART
MULTI-
LOAD/EJECT
light stops blinking
light
a