All Memory Clear - TEC MA-516-100 SERIES Owner's Manual

All Memory Clear

If the register becomes completely inoperative due to battery discharge or malfunction of the program memory, the
All Memory Clear operation must be carried out. When an All Memory Clear is operated, all the memory contents that
have been stored in the RAM will be cleared (i.e., the programmed data and the sales data). Along with the clearing
process, the designated zero-amount format is set and "Initial Data" and "Initial Status" for respective programming
items are automatically set.
Warning: This clear operation deletes all programmed data and sales data stored in the register's memory.
(i.e., the register goes back to initial status.)
Operating Procedure
Condition: Any time, outside or during any operation sequence except during
Operation:
Use the S Key to turn the
Control Lock to "BLIND".
Depress the following Numeric Key according to the display and print format for zero amount:
Numeric Key
3 9
1 9
AT/TL
Depress the
An All Memory Clear receipt is issued.
NOTE: When the All Memory Clear is operated, the condition "after all sales data reset" is obtained, just as
"Status Clear" or "Sales Memory Clear". Therefore, no Reset Reports need to be taken for starting any
programming operation.
Key Setting or Key Location Changing (Chapter 15) or System
Option Setting (Chapter 22).
X
REG
OFF
SET
Zero-amount Format
0 . 0 0
. 0
All Memory Clear Symbol Line
(39 for Numeric 39, or 19 for Numerlc 19)
Receipt Consecutive No. is reset to
key.
0001.
- 157 -
MGR
-
Z
(BLIND)
for use in US or Canada
Zero-amount Display & Print Format designated here.
EO1-11116
MA-516-100 SERIES