TEC MA-516-100 SERIES Owner's Manual page 156

Abnormal sound generates.
Cause 1: Paper roll or ribbon cassette is not placed correctly.
Measure: Place the paper roll or ribbon cassette correctly. (Refer to page 16 or 143.)
Cause 2: Failure of the printer itself
Measure: Ask the store where purchased.
Stamp does not work.
Cause 1: Stamp is not installed correctly.
Measure: Install the stamp correctly. (Refer to page 144.)
Cause 2: Failure of the stamp mechanism
Measure: Ask the store where purchased.
Print of the stamp is too light.
Cause 1: Stamp ink is not enough.
Measure: Replenish the ink. (Refer to page 144.)
Paper jam has occurred.
Cause: Paper roll is placed on the skew, or foreign substance exits in the paper path of the inside of the printer.
Measure: Remove the jammed paper as follows.
1
To open the upper side of the printer after releasing the
claws securing it, press simultaneously two levers
(green) provided on both sides of the printer in the
direction of the arrow.
2
Raise up the upper side of the printer in the direction of
the arrow, then remove the jammed paper. After remov-
ing it, return the upper side of the printer until it clicks.
- 152 -
EO1-11116
MA-516-100 SERIES