TEC MA-516-100 SERIES Owner's Manual page 155

Paper roll wrinkles.
Cause 1: Paper roll is not placed correctly, or placed on the skew.
Measure: Place the paper roll correctly. (Refer to page 16.)
Cause 2: Failure of the printer itself
Measure: Ask the store where purchased.
Printer prints nothing.
Cause 1: Ribbon cassette is not installed.
Measure: Install the ribbon cassette. (Refer to page 143.)
Cause 2: Ribbon cassette reaches its life, deteriorates, or is damaged.
Measure: Replace the ribbon cassette with a new one.
Cause 3: Status lamp "R OFF" is illuminated. (In case that nothing is printed on the receipt but not the journal)
Measure: Depress the [LOG/RECEIPT] key to extinguish the lamp.
Cause 4: Failure of the printer itself
Measure: Ask the store where purchased.
Printing as a whole is too light.
Cause 1: Ribbon cassette reaches its life, deteriorates, or is damaged.
Measure: Replace the ribbon cassette with a new one. (Refer to page 143.)
Printing gets stained.
Cause 1: Printer drum gathers paper dust.
Measure: It is necessary to clean the inside of the printer, therefore ask the store where purchased.
Printing is uneven or too light.
Cause 1: Ribbon cassette reaches its life, deteriorates, or is damaged.
Measure: Replace the ribbon cassette with a new one. (Refer to page 143.)
- 151 -
EO1-11116
MA-516-100 SERIES