Toshiba TECRA M9 User Manual page 72

12. Tuck the keyboard ribbon cable into the groove under the memory
module cover.
Screws
13. Insert the tabs on the front of the keyboard into the corresponding
notches on the computer and place the keyboard down.
When seating the keyboard, be sure to connect the circuit board if the
keyboard ribbon cable was pulled out while you were removing the
keyboard.
14. Replace the keyboard and secure it using the two screws.
Be sure to use all two screws removed in step 7. Make sure no screw was
dropped into the computer. Make sure no foreign matter can be found
inside the computer.
Screws
15. Set the keyboard brace into its groove and hold down to secure the
latches.
16. Install the battery pack. Refer to
Chapter 6, Power and Power-Up Modes, for details.
17. Turn your computer over.
18. Turn the computer on and make sure the added memory is recognized
- to confirmed it, Start -> Control Panel -> System and Maintenance -
> System icon.
User's Manual
Figure 3-9 Seating the memory module cover
Figure 3-10 Replace the keyboard
Replacing the battery pack
Hardware, Utilities and Options
Memory module cover
Keyboard ribbon cable
Keyboard
Tabs
section in
3-21