Inserting a module
Insert the Ultra Slim Bay HDD Adaptor as described below.
1. Insert the Ultra Slim Bay HDD Adaptor in the computer as shown below
and press until the ejector clicks.
2. Remove the Ultra Slim Bay lock screw from the Unlock position.
3. If you want to lock the Ultra Slim Bay HDD Adaptor, set the Ultra Slim
Bay lock screw in the hole for the lock position.
Using optical disc drives
The full-size drive provides high-performance execution of CD/DVD-ROM-
based programs. You can run either 12 cm (4.72") or 8 cm (3.15")
CD/DVDs without an adaptor. An ATAPI interface controller is used for
CD/DVD-ROM operation. When the computer is accessing a CD/DVD-
ROM, an indicator on the drive glows.
Use the WinDVD application to view DVD-Video discs.
If you have a DVD Super Multi drive, refer also to the
DVD Super Multi drives
When the power of the optical disc drive is off, pressing the FN + Tab keys
will turn the power of the optical disc drive on. Furthermore, it is possible to
set it to turn the power of the optical disc drive on and eject the tray at the
same time.
Loading discs
To load CD/DVDs, follow the steps below.
1. When the computer's power is on, press the eject button to open
the disc tray slightly.
User's Manual
Ultra Slim Bay HDD Adaptor
Figure 4-5 Inserting the Ultra Slim Bay HDD Adaptor
section for precautions on writing to CDs/DVDs.
Operating Basics
Lock screw
(Lock position)
Unlock position
Writing CD/DVDs on
4-11