Rps Enablement Option - HP ProLiant ML310e User Manual

Select Enable, and then press the Enter key to modify the TPM Functionality setting.
5.
Press the Esc key to exit the current menu, or press the F10 key to exit RBSU.
6.
Reboot the server.
7.
Enable the TPM in the OS. For OS-specific instructions, see the OS documentation.
8.
CAUTION:
to follow the proper procedures for updating the system or option firmware, replacing the system
board, replacing a hard drive, or modifying OS application TPM settings.
For more information on firmware updates and hardware procedures, see the HP Trusted Platform Module
Best Practices White Paper on the HP website (http://www.hp.com/support).
For more information on adjusting TPM usage in BitLocker™, see the Microsoft website
(http://technet.microsoft.com/en-us/library/cc732774.aspx).

RPS enablement option

Install the RPS enablement option to improve power efficiency and enable power redundancy. Power
redundancy requires the installation of two power supply modules. This module is a separately purchased
option and is not part of the RPS enablement kit. When the RPS enablement option is installed, the lower
media drive bay will not be available.
CAUTION:
all bays are populated with either a component or a blank.
To install the component:
Power down the server (on page 18).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Unlock and open the tower bezel
3.
Remove the access panel (on page 20).
4.
Disconnect all drive power cables and the non-hot-plug power supply cables.
5.
When a TPM is installed and enabled on the server, data access is locked if you fail
To prevent improper cooling and thermal damage, do not operate the server unless
("Unlock the tower bezel" on page 19).
Hardware options installation 57