Expansion Board Options - HP ProLiant ML310e User Manual

Install the DIMM.
7.
Install the air baffle (on page 22).
8.
Install the access panel (on page 21).
9.
Lock the tower bezel.
10.
Connect each power cord to the server.
11.
Connect each power cord to the power source.
12.
Power up the server (on page 18).
13.
After installing the DIMMs, to configure the memory protection mode, use RBSU
Utility" on page 72).

Expansion board options

The server has both full-height and low-profile expansion slots for controller option installation
expansion slot
CAUTION:
all PCI slots have either an expansion slot cover or an expansion board installed.
To install the component:
Power down the server (on page 18).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Unlock the tower bezel (on page 19).
3.
Remove the access panel (on page 20).
4.
Remove the air baffle (on page 21).
5.
definitions" on page 12).
To prevent improper cooling and thermal damage, do not operate the server unless
("HP ROM-Based Setup
("PCIe
Hardware options installation 48