Server Operations; Power Up The Server; Power Down The Server; Access Panel - HP ProLiant ML110 - G2 Server User Manual

Server operations

Power up the server

To power up the server, press the Power On/Standby button.

Power down the server

WARNING:
equipment, remove the power cord to remove power from the server. The front panel Power
On/Standby button does not completely shut off system power. Portions of the power supply
and some internal circuitry remain active until AC power is removed.
IMPORTANT:
Back up the server data.
1.
Shut down the operating system as directed by the operating system documentation.
2.
Press the Power On/Standby button to place the server in standby mode. When the server activates
3.
standby power mode, the system power LED changes to amber.
Disconnect the power cords.
4.
The system is now without power.

Access panel

WARNING:
internal system components to cool before touching them.
CAUTION:
removed. Operating the server in this manner results in improper airflow and improper
cooling that can lead to thermal damage.
Power down the server (on page 6).
1.
Extend the server from the rack, if applicable.
2.
Loosen the two thumbscrews located on the server rear panel, if applicable.
3.
Slide the access panel back about 1.5 cm (0.5 in).
4.
Lift and remove the access panel.
5.
To install the component, reverse the removal procedure.
To reduce the risk of personal injury, electric shock, or damage to the
If installing a hot-plug device, it is not necessary to power down the server.
To reduce the risk of personal injury from hot surfaces, allow the drives and the
Do not operate the server for long periods with the access panel open or
Server operations 6