Main Drive Assembly - Lexmark T620 Service Manual

4069-5XX/7XX

Main Drive Assembly

1. Remove the inner EMC shield.
2. Remove the gear guard.
3. Remove the developer drive assembly.
4. Remove the transfer shaft (A) through the bottom of the printer.
5. Remove all cables from the cable clamps (B) on the main drive
assembly.
6. Remove the ground cables (F). Be sure to reinstall the ground
cables to the same location.
7. Remove the main drive assembly mounting screws (C).
8. Remove the link (D) from the rear of the main drive assembly.
9. Disconnect the cable from the main drive motor.
Repair Information
4-43