Main Drive Assembly Removal - Lexmark T520 Service Manual

Infoprint 1120 and 1125

Main Drive Assembly Removal

1. Remove the inner EMC shield.
2. Remove the gear guard.
3. Remove the developer drive assembly.
4. Remove the transfer shaft (A) through the bottom of the printer.
5. Remove all cables from the cable clamps (B) on the main drive
assembly.
6. Remove the ground screw (C), and remove the engine board
shield.
7. Remove the main drive assembly mounting screws (D).
8. Remove the link from the rear of the main drive assembly.
9. Disconnect the cable from the main drive motor.
10. Remove the main drive assembly.
Note: Be sure the main drive assembly gear shaft aligns with the
hub on the left side frame when reinstalling the main drive assembly.
Repair Information
4-43