Registering Handsets; De-Registering A Handset; Restore Default Settings; Language - Telstra 7300a User Manual

Handset settings

Registering handsets

If you have purchased a Telstra 7300/7300a multi handset pack, the handsets in these packs are
already pre-registered to the main base.
If however you de-register a handset and need to re-register it back to a Telstra 7300/7300a base at
any stage:
1. Press and enter
2. Registration is displayed, press
3. Register is displayed, press and Enter PIN will be displayed.
4. Enter the base PIN (original setting 0000) and press
5. The handset will display Searching, press and hold the
confirmation tone.
6. The handset will temporarily display Registered then will display Handset and will be
automatically assigned the next handset number.
Your Telstra 7300/7300a is not GAP compatible and registration is therefore generally limited to other Telstra 7300/7300a
handsets. The Registration and De-registration menu's are therefore "hidden" and can only be accessed after entering the
code

De-registering a handset

You can de-register any handset from a base using any of the handsets that are registered to it.
1. Press and enter
2. Registration is displayed, press
until Deregister is displayed, press
3. Press or
4. Enter the base PIN (original setting 0000) and press
44
using the keypad.
.
.
button on the base until you receive a
using the keypad.
.
and Enter PIN will be displayed.
.
Handset settings
5. Use or to display the handset number you wish to de-register, then press
6. Deregister? will be displayed, press

Restore default settings

You can reset your Telstra 7300/7300a handset to its default (original) settings.
1. Press to open the main menu.
until the display shows Setup h/set and press
2. Press or
until Reset is displayed and press
3. Press or
4. Reset? is displayed. Press . Saved is displayed.

Language

You can change the default language used by your Telstra 7300/7300a from English to German or
Turkish.
1. Press to open the main menu.
until the display shows Setup h/set and press
2. Press or
until Language is displayed and press
3. Press or
4. Scroll or to choose the default language and press
5. Press and hold to return to standby.
again to confirm.
.
.
.
.
to confirm.
.
45