To Test The Installation; Configuring The Software - Sun Microsystems Sun PCI High Speed User Manual

5. After the system reboots, verify the installation by typing the following
commands:
# /usr/bin/pkginfo | grep SUNWhsip
system SUNWhsip SunHSI/P Driver for PCI
system SUNWhsipm SunHSI/P Man Pages for PC
system SUNWhsipu SunHSI/P Utilities for PCI
# modinfo | grep HSIP
126 7bb24000 17708 150 1 HSIP (PT-PCI334 Driver)
# grep HSIP /etc/path_to_inst
"/ssm@0,0/pci@18,700000/pci1214,334a@2" 0 "HSIP"
The output shows that the packages are installed, the driver is loaded, and that
the software is mapped to the adapter.

▼ To Test the Installation

●
Type the following command (replace n with the adapter port you are testing):
# hsip_loop -c 100 -l 2048 -s 2048000 -t 1 hihpn
This command runs an internal loopback test. For more information, see the
hsip_loop(1M) man page.

Configuring the Software

To configure the adapter for the Point-to-Point Protocol (PPP), see
Point-to-Point Protocol" on page
Guide: Network Services documentation for the version of Solaris that you are
running. These documents are available from the following web site:
http://docs.sun.com/
To configure the adapter for the X.25 9.2 protocol, refer to the Solstice X.25 9.2
Administration Guide (806-1234). The X.25 9.2 documents are available from the
following web site:
http://docs.sun.com/
14 Sun PCI High Speed Quad Port Serial Interface Adapter User's Guide • May 2010
3-15. Also refer to the Solaris System Administration
"To Configure for