Pre-Operation Checks - Subaru EH025 Instructions For Use Manual

3. PRE-OPERATION CHECKS

Oil gauge
Upper level
Lower level
5W
10W
Single
grade
Multi
grade
-20 -10
Ambient
temperature
-4 14
20W
#20
#30
#40
10W-30
10W-40
0 10 20 30
40
32 50 68 86
104
CHECK ENGINE OIL
Before checking or refilling engine oil, be
sure the engine is located on a stable, level
surface and stopped.
Do not thread the gauge into oil filler to
check oil level.
If the oil level is below the lower level
line on the dipstick, refill with the proper
oil (see table) up to the upper level (up to
the point of overflowing the filler neck).
OIL CAPACITY
(EH035V) Before filling oil, make sure that
the oil drain screw is secured thoroughly.
Change oil if it is contaminated.
(See page 11 Maintenance Schedule.)
Use class SF (API classification) or
higher grade oil.
If multi-grade oil is employed, oil
consumption tends to increase when
the ambient temperature is high.
Wipe off any spilled oil before starting
the engine.
CHECK FUEL
Do not refuel while smoking, near an
open flame or other potential hazards.
Stop the engine and open the cap.
Incline the engine as fuel inlet upward,
then refill fuel to the upper level. Do
not fill fuel too much.
Use automotive unleaded gasoline only.
This engine is 4-stroke gasoline engine.
This engine is certified to operate on
automotive unleaded gasoline.
When filling the fuel tank, always use
the fuel filter.
Wipe off any spilled fuel before starting
the engine.
- 7 -
EH025 : 80 mL
EH035 : 100 mL
CAUTION