Advertisement

The engine exhaust from this product contains
chemicals known to the State of California to
cause cancer, birth defects or other reproductive
harm.
FEDERAL EMISSION COMPONENT DEFECT WARRANTY and CALIFORNIA
EMISSION CONTROL WARRANTY are applicable to only those engines
complied with EPA (Environmental Protection Agency) and CARB (California
Air Resources Board) emission regulations in the U.S.A.
To the engines exported to and used in the countries other than the U.S.A.,
warranty service shall be performed by the distributor in each country in
accordance with the standard Robin engine warranty policy as applicable.
To show compliance with California emission regulations, a hangtag has been
provided displaying the Air Index level and durability period of this engine.
The Air Index level defines how clean an engine's exhaust is over a period of
time. A bar graph scaled from "0" (most clean) to "10" (least clean) is used to
show an engine's Air Index level. A lower Air Index level represents cleaner
exhaust from an engine.
The period of time (in hours) that the Air Index level is measured is known as
the durability period. Depending on the size of the engine, a selection of time
periods can be used to measure the Air Index level (see below).
Descriptive Term
Applicable to Emissions Durability Period
Moderate
-
Intermediate
-
Extended
-
Notice : This hangtag must remain on this engine or piece of equipment, and
only be removed by the ultimate purchaser before operation.
WARNING :
NOTICE
NOTICE

AIR INDEX

50 hours (engine from 0 to
125 hours (engine greater than 80 cc)
125 hours (engine from 0 to 80 cc)
250 hours (engine greater than 80 cc)
300 hours (engine from 0 to 80 cc)
500 hours (engine greater than 80 cc)
80 cc)

Advertisement

Table of Contents
loading

Summary of Contents for Subaru EH025A

  • Page 1: Air Index

    WARNING : The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. NOTICE FEDERAL EMISSION COMPONENT DEFECT WARRANTY and CALIFORNIA EMISSION CONTROL WARRANTY are applicable to only those engines complied with EPA (Environmental Protection Agency) and CARB (California Air Resources Board) emission regulations in the U.S.A.
  • Page 2 FEDERAL EMISSION COMPONENT DEFECT WARRANTY EMISSION COMPONENT DEFECT WARRANTY COVERAGE - This emission warranty is applicable in all States, except the State of California Fuji Heavy Industries Ltd. and Robin America Inc., Wood Dale Illinois, (herein "ROBIN AMERICA") warrant to the initial retail purchaser and each subsequent owner, that this utility equipment engine (herein "engine") was designed, built, and equipped to conform at the time of initial sale to all applicable regulations of the U.S.
  • Page 3 *The replacement parts used for required maintenance services. *Consequential damages such as loss of time, inconvenience, loss of use of the engine of equipment, etc. *Diagnosis and inspection charges that do not result in warranty-eligible service being performed. *Any non-authorized replacement part, or malfunction of authorized parts due to use of non- authorized parts.
  • Page 4: Your Warranty Rights And Obligations

    CALIFORNIA EMISSIONS CONTROL WARRANTY STATEMENT YOUR WARRANTY RIGHTS AND OBLIGATIONS The California Air Resources Board and FUJI HEAVY INDUSTRIES LTD. are pleased to explain the emissions control system’s warranty on your 2007 and later small off-road engine. In California, new equipment that use small off-engines must be designed, built, and equipped to meet the State’s stringent anti-smog standards.
  • Page 5 DEFECTS WARRANTY REQUIREMENTS: (a) The warranty period begins on the date the engine or equipment is delivered to an ultimate purchaser. (b) General Emissions Warranty Coverage. FUJI HEAVY INDUSTRIES LTD. must warrant to the ultimate purchaser and each subsequent owner that the engine or equipment is: (1) Designed, built, and equipped so as to conform with all applicable regulations adopted by the Air Resources Board;...
  • Page 6 (8) Throughout the emissions warranty period defined in Subsection (b)(2), the manufacturer must maintain a supply of warranted parts sufficient to meet the expected demand for such parts. (9) Any replacement part may be used in the performance of any warranty maintenance or repairs and must be provided without charge to the owner.
  • Page 7 (e) MAINTENANCE STATEMENTS It is your responsibility to have all scheduled inspection and maintenance services performed at the times recommended in the 2007 and later Owner's Manual and to retain proof that inspection and maintenance services are performed at the times when recommended.
  • Page 8 FOREWORD Thank you very much for purchasing a ROBIN ENGINE. Your ROBIN ENGINE can supply the power to operate various sorts of machines and equipment. Please take a moment to familiarize yourself with the proper operation and maintenance procedures in order to maximize the safe and efficient use of this product.
  • Page 9: Table Of Contents

    CONTENTS 1. SAFETY PRECAUTIONS ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ 1 2.
  • Page 10 SYMBOLS Read the owner's manual. Stay clear of the hot surface. Exhaust gas is poisonous. Do not operate in an unventilated area. Stop the engine before refueling. Fire, open flame and smoking prohibited. Plus ; On (Run) positive polarity Off (Stop) Battery Engine start Engine oil...
  • Page 11: Safety Precautions

    1. SAFETY PRECAUTIONS Please make sure you review each precaution carefully. Pay special attention to statement preceded by the following words. WARNING “WARNING” indicates a strong possibility of severe personal injury or loss of life if instructions are not followed. “CAUTION”...
  • Page 12 WARNING : OTHER SAFETY PRECAUTIONS Place the protective covers over the rotating parts. ■ If rotating parts such as the drive shaft, pulley, belt, etc. are left exposed, they are potentially hazardous. To prevent injury, equip them with protective covers or shrouds. Be careful of hot parts.
  • Page 13 CAUTION : PRE-OPERATION CHECKS Carefully check fuel hoses and joints for looseness and fuel leakage. ■ Leaked fuel creates a potentially dangerous situation. Check bolts and nuts for looseness. A loose bolt or nut may cause serious ■ engine trouble. Check the engine oil and refill if necessary.
  • Page 14: Components

    2. COMPONENTS EH025 Plug cover Air cleaner Stop switch Clutch Fuel tank cap P.T.O. Shaft Fuel tank A Type P Type (Pump) Choke lever Carburetor Muffler Primer pump Oil gauge ( Oil filler ) Starter handle Recoil starter Engine serial No. - 4 -...
  • Page 15 EH035 Plug cover Air cleaner Clutch Fuel tank cap Fuel tank P.T.O. Shaft A Type Carburetor P Type (Pump) Choke lever Primer pump Muffler Starter handle Oil gauge (Oil filler) Recoil starter - 5 -...
  • Page 16 EH035V Fuel tank cap Fuel upper level upper level Fuel tank Oil drain screw Spark plug (Plug cap) Muffler Carburetor Choke lever Primer pump Starter handle Air cleaner Oil gauge (Oil filler) Fuel tank Fuel tank cap Recoil starter Clutch - 6 -...
  • Page 17: Pre-Operation Checks

    3. PRE-OPERATION CHECKS CHECK ENGINE OIL Before checking or refilling engine oil, be Oil gauge sure the engine is located on a stable, level surface and stopped. Do not thread the gauge into oil filler to ■ check oil level. Upper level If the oil level is below the lower level ■...
  • Page 18: Operating Your Engine

    4. OPERATING YOUR ENGINE STARTING STOP SWITCH PRIMER PUMP Set the throttle lever to the idling ■ position. If the stop switch is installed on the ■ engine.Set the stop switch to the Push the primer pump 7 to 10 times position "ON or I ".
  • Page 19: Stop Switch

    STOPPING STOP SWITCH CHOKE LEVER Set the throttle lever at the low ■ speed position and allow the engine to run at low speed for 2 or 3 minutes before stopping. If the stop switch is installed on the ■ engine.Set the stop switch to the After starting the engine, gradually ■...
  • Page 20: Easy Troubleshooting

    5. EASY TROUBLESHOOTING WHEN ENGINE DOES NOT START: Perform the following checks before you take ■ the engine to your Robin dealer. If you still have trouble after completing the checks, ■ take the engine to your nearest Robin dealer. Is the engine switch set ON? Is there enough compression? 1.
  • Page 21: Maintenance Schedule

    6. MAINTENANCE SCHEDULE MAINTENANCE, REPLACEMENT OR REPAIR OF EMISSION CONTROL DEVICES AND SYSTEMS MAY BE PERFORMED BY ANY NONROAD ENGINE REPAIR ESTABLISHMENT OR INDIVIDUAL. DAILY INSPECTION Before running the engine, check the following service items. Excessive vibration,noise Clean air cleaner element Safe surroundings Enough gasoline Enough clean engine oil...
  • Page 22 Periodic Maintenance Schedule table Every 8 hours Every Every Maintenance Items 200 hours (daily) 50 hours Clean engine and check bolts and nuts ● (Daily) ● (Refill daily Check and refill engine oil up to upper level) Clean air cleaner ●...
  • Page 23: How-To" Maintenance

    7. "HOW-TO" MAINTENANCE INSPECTING THE SPARK PLUG Clean off carbon deposits on the ■ spark plug electrode using a plug cleaner or wire brush. Check electrode gap. ■ Adjust gap 0.7 mm to 0.8 mm 0.7 to 0.8 mm (0.03 inches) (0.03 in.) Use a proper spark plug : ■...
  • Page 24 3) Remove the oil gauge, then tilt the engine and drain the oil into a pan or other receptacle. (EH035V) Remove the oil drain screw and drain the oil. 4) Put the engine on a level surface, then fill with the oil up to the point of overflowing the filler neck.
  • Page 25 CLEANING FUEL FILTER Remove the hose clamp and pull out the fuel filter from fuel pipe. Wash the fuel filter with kerosene. After washing, reassemble it. If the fuel filter is heavy dirty, replace it with new one. CLEANING AIR CLEANER EH025 Choke lever Dirty air cleaner element will cause...
  • Page 26 CHECKING BOLTS, NUTS AND SCREWS Retighten loose bolts and nuts. Check for fuel and oil leaks. Replace damaged parts with new ones. Keep safety in your mind. FUEL PIPE REPLACEMENT Replace the fuel pipe every 1 year. If the fuel leakage is found on the fuel pipe, replace it immediately.
  • Page 27: Preparations For Storage

    8. PREPARATIONS FOR STORAGE DISCHARGE FUEL (NO SMOKING !) In case the engine is not going to be used for more than one month, discharge fuel thoroughly from fuel tank and carburetor in order to prevent from hard starting and/or poor engine operation due to deteriorated fuel when you use the engine next time.
  • Page 28: Specifications

    9. SPECIFICATIONS MODEL EH025A EH025P EH035A EH035P EH035V Air-Cooled, 4-Stroke, Single Cylinder, Overhead valve, Type Gasoline Engine Bore x Stroke in.(mm) 1.34 x 1.06 (34 x 27) 1.54 x 1.10 (39 x 28) Displacement cu. in. (cm 1.49 (24.5) 2.04 (33.5) Maximum Output 0.81 (1.1) / 7000...
  • Page 29 ISSUE EMD-EU2308 FUJI HEAVY INDUSTRIES LTD. I N D U S T R I A L P R O D U C T S C O M P A N Y 4-410 ASAHI,KITAMOTO-SHI,SAITAMA,364-8511,JAPAN TEL:+81-48-593-7798,FAX:+81-48-593-7946 h t t p : / / w w w . f h i . c o . j p / r o b i n /...

This manual is also suitable for:

Eh035aEh025pEh035vEh035p

Table of Contents