Table of Contents
Advertisement
VIEWING WORKOUT DATA DURING A PROGRAM
Workout data is shown in three windows on the Stepper Display Panel: the Information Window (located at the top of the Display Panel)
and the Upper and Lower Data Information Windows (located inside the Motivational Track, to the right of the Graphic Display).
Information shown in the Information Window during a workout includes elapsed time, number of floors climbed, and heart rate (HR),
when in use. After the workout is complete, workout summary information is shown in the Information Window.
The Information Window also displays important instructions and cues throughout the workout.
The Upper and Lower Data Information Windows also display information during a workout.
1. Press the Upper Data Information Window S
ed by an LED next to the parameter name):
I
CALORIES - Shows your aggregate caloric expenditure thus far in your workout.
I
CAL/HR - Shows your current caloric expenditure per hour based on your current difficulty level and stepping rate.
I
WATTS - Shows your current watts expenditure at that specific time during your workout.
Press the S
2. Press the Lower Data Information Window S
ed by an LED next to the parameter name):
I
DISTANCE - Shows the total number of vertical feet or meters you have climbed thus far.
I
SPEED - Shows the speed at which you are currently stepping, in steps-per-minute.
I
METS - Shows your current METS expenditure at that specific time during your workout.
PAUSE MODE
If you come to a complete stop during your workout (SPM is less than 10), the Stepper will enter a "pause" mode. To continue your work-
out, begin stepping before the "pause" timer expires and your workout data will not be lost.
COOLDOWN CYCLE
Once you have completed your workout, the Stepper enters a two-minute Cooldown cycle.
The Stepper software is programmed to properly decrease difficulty level to provide a cooldown.
1. You can adjust the difficulty L
I
Use the
decrease the difficulty L
I
When the desired difficulty L
L
.
EVEL
2. When the Cooldown cycle ends, your workout summary displays in the Information Window. If you wish to exit the Cooldown
cycle before it ends automatically, stop stepping.
USING THE PERSONAL FAN
The STAR TRAC E-ST STEPPER is equipped with a built-in personal fan to increase your comfort during a workout. You can control
the fan speed during your workout.
I
Press the
key, as necessary, to cycle the personal fan from OFF to HIGH to LOW to OFF. An LED indicator lights to
show the currently selected fan speed.
I
The fan remains set at the set speed if you pause your program, unless your workout was less than two minutes in length.
I
The fan turns off automatically if you exit your workout, or when you complete your workout program.
I
The fan turns off automatically if you pause your program and the time elapsed is less than two minutes.
STAR TRAC E-ST STEPPER O
CROLL
key to toggle between data during your workout.
CROLL
CROLL
during Cooldown.
EVEL
keys to enter a difficulty L
in 1 unit increments.
EVEL
has been entered by using the
EVEL
'
M
WNER
S
ANUAL
key to view the following workout data (the current data display is indicat-
key to view the following workout data (the current data display is indicat-
(from 1 to 20); or press the
EVEL
or
key, as desired, to increase or
keys, press the
key to accept the displayed
17
Hide quick links:
Advertisement
Table of Contents
