Star Micronics MULTI-FONT NX-1000II User Manual page 79

IMode! ASCII
I Decimal
I Hexadecimal I
-.
,—
—.
—
.
—
.
—
L.-
L-
~-
,—
-.
Select double or quadruple size
Both <ESC> "h- n
27104 n IB 68 n
I
Selects the size of subsequent characters as shown below. Extra-high
characters align akmg the cap-line of normal characters, with the base
iine temporarily moving down. Line spacing is temporarily doubled when
n =
1, 5 or 6 and quadrupled when n =
2.
To print correctly when
n
=
3,4,5 or 6, set the line spacing to 24/216(1/9) of an inch with < ESC>
"3" <24>, and print the samecharacters
twice,
upper half on one line,
lower half on the next. For accurate alignment of the two halves, select
unidirectional printing with < ESC > "U" <1>.
n
Effect
O Normal size
1 Double-high, double-wide
2 Quadruple-high, quadruple-wide
3 Double-high, double-wide (Lower half only)
4 Double-high, double-wide (Upper half only)
5 Quadruple-high, quadruple-wide (Lower half only)
6 Quadruple-high, quadruple-wide (Upper half only)
Print
double-height characters
Mode ASCII Decimal Hexadecimal
< ESC > "w" "l" 27 119 49
IB 77 31
Both
<ESC>
"w" <1>
27 119 1 IB 77 01
Prints subsequent characters at double height without moving the base
line, and without changing the line spacing. Temporarily cancels
super/subscript and condensed printing modes.
Return to normal height
Mode
ASCII
Decimal Hexadecimal
< ESC > "w"
"o"
Both
27 119 48
IB 77 30
<ESC>
"w" <0>
27 119 0 IB 77 00
Terminates double-height printing and prints subsequent characters at
normal height. Resumes super/subscript and condensed printing if these
modes were in effect before double height was selected.