Star Micronics MULTI-FONT NX-1000II User Manual page 39

5. Press the Paper Feed switch and hold it down.
three switchesdown. In about three seconds you
simalimz that the buffer has been cleared.
Continue holding all
will hear a beep tone
6. R;lease-all three switches, make any necessary control panel settings,
then set the printer back on-line.
It is essential to halt the printing program on the computer before you
go off-line. Otherwise, when you go back on-line the computer will start
sending data again and the printer will continue printing, with missingdata
where the buffer was cleared.
.
L
k
'L
L-
-
,