Star Micronics MULTI-FONT NX-1000II User Manual page 45

I
-..
-..
-.
L
\
-
—.
k-
!.-
.
\
L
\
L
$
Most printer commands consist of the escape code followed by one or
more letters or numbers. Some examples are:
< ESC > WI Double-width characters
c ESC > W() Normal width
< ESC >4
Italic
< ESC >5
Upright
Two lines with these commands embedded are shown below, together
with the printed result.
File:
<ESC >WIPRINT'ER COMMANDS< ESC>WO
cun he 1P you to use <ESC )4ita
1i c<ESC >5 print.
Printout:
I?R 1 NZZZR COIYllWANDS
can he 1p you to use ~ ta 1 ic print.
You will probably not see the symbol < ESC > on the screen, but a
different symbolsuch as "E or '[, or perhaps no symbolat all. This depends
on your software.
After printing the first page of a long job, you may want to pause to
check that the printing is correctly formatted. Press the On Line switch,
setting the printer off-line. Printing will stop immediately. To resume
printing, press the On Line switch again.
If you need to abandon a printingjob before it is finished,your software
should provide a command for this purpose. Another simple expedient is
to switch the printer's power off.