Problems with External Video Equipment
No picture appears on the screen.
■
Make sure the equipment is turned on.
■
Press the
Power
■
Press the
or
■
Make sure you don't have cables connected to more than one video port. You can only
use one connection at a time (see page 23).
You see the message
■
Make sure the equipment is turned on.
■
Make sure your cable(s) are connected correctly (see page 23).
■
Press the
button on MovieMate or the remote control to select the external video
source. Allow a few seconds for MovieMate to sync up.
You see the message
Press the
button on the remote control and check the
page 45).
The picture is cut off (too large) or too small.
Press the
button on the remote control and select the appropriate aspect ratio.
The picture is distorted.
■
If you're using an extension cable, electrical interference may affect the signal.
■
Check the solutions on pages 58 and 59.
The colors are not right.
■
Press the
button on the remote control and check the Video Signal setting (see
page 45).
■
Press the
button on the remote control to select the best setting for your viewing
environment.
■
Adjust the
Color Saturation
button on MovieMate or on the remote control.
button on the external equipment.
Play
.
No Signal
Signal not supported.
or
settings. See page 44.
Tint
setting (see
Video Signal
Problem Solving
61