Fcc Compliance Statement - Epson MovieMate 30s User Manual

■
Make sure there is at least 4 inches of space between the intake ventilation slots and the wall or
other object.
■
Do not use the projector with the lens cover on; otherwise, the cover could melt and cause injury.
■
Do not turn the volume too high, especially when using headphones. Listening to high volume
sounds over an extended period can damage your hearing. Sudden high volume can also damage
the speakers.
WARNING: The cord included with this product contains chemicals, including lead, known to the
State of California to cause birth defects or other reproductive harm. Wash hands after handling.
(provided in accordance with Proposition 65 in Cal. Health & Safety Code § 25249.5 et seq)

FCC Compliance Statement

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio or television reception. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause interference to radio
and television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
■ Reorient or relocate the receiving antenna.
■ Increase the separation between the equipment and receiver.
■
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
■
Consult the dealer or an experienced radio/TV technician for help.
The connection of a non-shielded equipment interface cable to this equipment will invalidate the FCC
Certification of this device and may cause interference levels which exceed the limits established by the
FCC for this equipment. It is the responsibility of the user to obtain and use a shielded equipment
interface cable with this device. If this equipment has more than one interface connector, do not leave
cables connected to unused interfaces. Changes or modifications not expressly approved by the
manufacturer could void the user's authority to operate the equipment.
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment
Regulations.
70
Specifications and Notices
For United States Users
WARNING
For Canadian Users