Problems With External Video Equipment - Epson MovieMate 25 User Manual

Problems with External Video Equipment

No picture appears on the screen.
■
Make sure the equipment is turned on.
■
Press the
Power
■
Press the or
■
Make sure you don't have cables connected to both the S-video and Video ports. You can
only use one connection at a time (see pages 35 and 36).
You see the message
■
Make sure the equipment is turned on.
■
Make sure your cable(s) are connected correctly (see pages 35 and 36).
■
Press the button on MovieMate or the remote control to select the external video
source. Allow a few seconds for MovieMate to sync up.
You see the message
Press the button on the remote control and check the
page 34).
The picture is cut off (too large) or too small.
Press the button on the remote control and select the appropriate aspect ratio.
The picture is distorted.
■
If you're using an extension cable, electrical interference may affect the signal.
■
Check the solutions on pages 48 and 49.
The colors are not right.
■
Press the button on the remote control and check the
page 34).
■
Press the button on the remote control to select the best setting for your viewing
environment.
■
Adjust the
Color Saturation
button on MovieMate or on the remote control.
button on the external equipment.
Play
.
No Signal
Signal not supported.
or settings. See page 33.
Tint
setting (see
Video Signal
setting (see
Video Signal
Problem Solving
51