Problems With External Video Equipment - Epson MovieMate 72 User Manual

Problems with External Video Equipment

No picture appears on the screen.
■
Make sure the equipment is turned on.
■
Press the
■
Press the
■
Make sure you don't have cables connected to more than one video port. You can only
use one connection at a time (see page 23).
You see the message
■
Make sure the equipment is turned on.
■
Make sure your cable(s) are connected correctly (see page 23).
■
Press the
source. Allow a few seconds for MovieMate to sync up.
You see the message
Press the
page 43).
The picture is cut off (too large) or too small.
Press the
The picture is distorted.
■
If you're using an extension cable, electrical interference may affect the signal.
■
Check the solutions on pages 55 and 56.
The colors are not right.
■
Press the
page 43).
■
Press the
environment.
■
Adjust the
58
Problem Solving
button on MovieMate or on the remote control.
or button on the external equipment.
Play
.
No Signal
button on MovieMate or the remote control to select the external video
Signal not supported.
button on the remote control and check the
button on the remote control and select the appropriate aspect ratio.
button on the remote control and check the
button on the remote control to select the best setting for your viewing
or
Color Saturation
settings. See page 41.
Tint
setting (see
Video Signal
setting (see
Video Signal