Panasonic PT-RW330U Operating Instructions Manual page 110

Chapter 5 Maintenance — Light source/temperature indicator
Temperature indicator <TEMP>
Indicator status
Status Warm-up status
f Did you turn on the
power when the
Cause room temperature
was low (about 0 °C
(32 °F))?
f Wait at least five
minutes in the
current status.
f Install the projector
Solution
in a location
with an ambient
temperature of 0 °C
(32 °F) to 45 °C
(113 °F)
*1 When using the projector at high altitudes (1 400 m (4 593') – 2 700 m (8 858') above sea level), the ambient temperature will be 0 °C (32 °F) –
40 °C (104 °F).
Note
f If the temperature indicator <TEMP> is still lit or flashing after taking the preceding measures, ask your dealer to repair the projector.
110 - ENGLISH
Lighting in red
Internal temperature is
high (warning).
f Is the air intake/exhaust port blocked?
f Is the room temperature high?
f Remove any objects that are blocking the air intake/exhaust port.
f Set up the projector in a location with an ambient temperature of
0 °C (32 °F) to 45 °C (113 °F)
condensation).
f Do not use the projector at high elevations 2 700 m (8 858') or higher
above sea level.
*1 .
Flashing in red Flashing in red
(1 time)
Internal temperature Internal temperature
is high (during is high (standby
projection). warning).
, and a humidity of 20 % to 80 % (no
*1
Flashing in red
(2 time) (3 time)
The fan has stopped.
―
f Set the <MAIN
POWER>
switch to <OFF>
( x page 34), and
consult your dealer.