Setting Password Protect - Epson EMP-1715/1710 User Manual

Security Functions

Setting Password Protect

f
Use the following procedure to set Password Protect.
Procedure
A
Hold down the [Freeze] button for about five
seconds.
The password protect setting menu is displayed.
Remote control
• If Password Protect is already activated, you must enter
q
the password.
If the password is entered correctly, the password protect
setting menu is displayed.
p.28
• When the password is set, stick the password protect
sticker in a visible position on the projector as a further
theft deterrent.
B
Turn on "Power On Protect".
(1) Select "Power On Protect", and then press the [Enter] button.
(2) Select "On", and then press the [Enter] button.
(3) Press the [Esc] button.
"Entering the password"
s
C
Turn on "Password Timer".
If you do not use this setting, go to step 4.
(1) Select "Password Timer", and then press the [Enter] button.
(2) Select "On", and then press the [Enter] button.
(3) Press the [Esc] button.
(4) Select "Timer", and then press the [Enter] button.
(5) While holding down the [Num] button, use the numeric buttons
to enter the setting time within a range of 1 to 9999 hours and
then press the [Enter] button. If you make a mistake entering
the time, press the [Esc] button and re-enter the time. The time
counter begins when you close the password protect setting
menu. The count is only done while the lamp is lit, and not
while it is turned off.
The time already counted is displayed in "Time-elapsed".
D
Turn on "User's Logo Protect".
(1) Select "User's Logo Protect", and then press the [Enter] button.
(2) Select "On", and then press the [Enter] button.
(3) Press the [Esc] button.
E
Turn on "Network Protect" (EMP-1715/1705 only).
(1) Select "Network Protect", and then press the [Enter] button.
(2) Select "On", and then press the [Enter] button.
(3) Press the [Esc] button.
27