Advertisement
Available languages
Available languages
5.
Rotate each retaining clip clock-
wise and press down until it
snaps into place over the handle.
6,
If the handle has excessive
movement,
it is improperly
installed. Check the following.
A.
Are both tabs inside the
handle (Step #3)?
B.
Does each clip pass through
both the saddle and handle
(Step #4)?
TO ASSEMBLE WHEELS
It will be necessary
to brace or support
one side of the air compressor
when
installing the wheels because the
compressor
will have a tendency
to
tip.
1.
Attach wheels with shoulder bolts
and nuts as shown.
2.
Tighten securely. NOTE: The air
compressor will sit level if the
wheels are properly installed.
The wheels and
handle do not
provide adequate
clearance,
stability
or support
for pulling the unit up and
down stairs or steps. The unit must
be lifted, or pushed up a ramp.
ASSEMBLE
RUBBER
FEET
1.
Attach rubber feet with the
screws, washers and nuts pro-
vided as shown in figure below.
2.
Tighten securely.
Nut
Wheel
?_?-=
Rubber Foot
"_-'- Screw
Shoulder
Bolt
OIL FOR PUMP
_This
compressor was
shipped with oil in
the pump crankcase. Check oil before
operating air compressor, see Check
Oil under Maintenance.
1000003598
12-ENG
Advertisement
