Advertisement
Available languages
Available languages
Become familiar with these terms
before operating the unit.
CFM:
Cubic feet per minute.
SCFM: Standard cubic feet per min-
ute; a unit of measure of air delivery.
PSmG: Pounds per square inch gauge;
a unit of measure of pressure.
Code Certification:
Products that
bear one or more of the following
marks: UL, CUL, ETL, CETL, have
been evaluated by OSHA certified
independent safety laboratories and
meet the applicable Standards for
Safety.
Cut-in Pressure:
While the motor
is off, air tank pressure drops as you
continue to use your accessory. When
the tank pressure drops to a certain
low level the motor will restart auto-
matically.
The low pressure at which
the motor automatically restarts is
called "cut-in" pressure.
Cut-Out
Pressure:
When an air com-
pressor is turned on and begins to
run, air pressure in the air tank begins
to build. It builds to a certain high
pressure before the motor automati-
cally shuts off, protecting your air tank
from pressure higher than its capacity.
The high pressure at which the motor
shuts off is called "cut-out" pressure.
Branch Circuit: Circuit carrying elec-
tricity from electrical panel to outlet.
This unit is capable of powering the following Accessories.
The accessories are
available through the current Power and Hand Tool Catalog or full-line Sears
stores.
Accessories
•
in Line Filter
Tire Air Chuck
Quick Connector Sets (various
sizes)
Air Pressure Regulators
Oil Fog Lubricators
Air Hose:l/4"
(6.4 mm), 3/8"
(9.5 mm) or 1/2" (12.7 mm) inside
diameter in various lengths
Refer to the selection chart located
on the unit to select the tools this unit
is capable of powering.
This air compressor pump is capable
of running continuously.
However,
to prolong the life of your air com-
pressor, it is recommended
that a
50%-75%
average duty cycle be
maintained;
that is, the air compres-
sor pump should not run more than
30-45 minutes in any given hour.
1000003598
10-ENG
Advertisement
