Craftsman 536.886150 Owner's Manual page 5

2- Screw, 5/16-t8 x 2 In. 2 -Washer, Hvsptlk 2- Nut, 5/1648 Reghex
Parts packed separately in carton (not shown full size)
2 - Ignition Keys
(Attached to engine in plastic bag) 1 - container 5W30 oil 1 - Snow Chute Assembly
_ CAUTION: Always wear safety
glasses or eye shields while assembling
snow thrower
TOOLS REQUIRED FOR ASSEMBLY
1 - Knife to cut carton and plastic ties
2 - 1/2 inch wrenches (or adjustable
wrenches)
2 - 9/16 inch wrenches (or adjustable
wrenches)
2 - 3/4 inch wrenches (or adjustable
wrenches)
1 - Pliers (to spread cotter pin)
1 _ Screwdriver
I - Measuring tape or ruler
The figure below shows the snow thrower in
the shipping carton
The figure below shows the snow thrower
completely assembled,
References to the right or left hand side
of the snow thrower are from the viewpoint
of the operator's position behind the unit,
Auger drive lever lever
Chute Crank
Shifter
lever
deflector
Lower handle
Upper
handle
aF, sembly
Height
adjust
/
Mounting nuts I