Craftsman 536.886150 Owner's Manual page 7

TO INSTALL SHIFTER LEVER KNOB
• Thread the hex nut found in the parts bag
onto shifter lever, Thread the shifter lever
knob onto the threaded end of the shifter
lever until it is snug against the hex nut
and the lip is pointed away from the en-
gine. Tighten hex nut against the bottom
of the shifter lever knob° See figure below
_"\ Knob
_\ Nut
Shifter Lever
NOTE_ If the cables have become discon-
nected from the clutch levers, reinstall the
cables as shown in next two figures
NOTE: Position cable through slots on
shifter plate,
"Z" fitting
4" Lg free state
Traction drive
3" Lg free stale
Auger drive
ing
- Install (3) ftatwashers and (3) nuts (found
in parts bag) on outside of flange ,,
- Tighten carriage bolts securely, NOTE:
Check fourth carriage bolt for tightness.,
Locknut
_" , Snow Chute Flange
,,_ _"_Carriage Bolts
TO CHECK/ADJUST CLUTCH
CONTROL CABLES
The control cables attached to the auger
clutch lever and traction clutch lever as
shown in figure below may need to be ad-
justed before you use your snow thrower
For instructions on checking or adjusting the
control cables. (See To Adjust Clutch Control
Cables paragraph on page17)
ve
spring lever spring cable
TO ASSEMBLE SNOW CHUTE
• Position snow chute on snow chute flange
and align the three holes in the snow
chute with holes in the snow chute flange
as shown in next figure
• Install (3) carriage bolts (found in parts
bag) from inside of chute as shown in next
figure°
HOW TO SET UP YOUR SNOW
THROWER
• Your snow thrower is equipped with height
adjust skids (see second figure on page 5)
on the outside of the auger housing, To
adjust the skid height for different
conditions, (see To Adjust Skid Height
paragraph on page 17)