How To Use The Hydrofoam Launcher; Cleaning And Applying Detergent - Craftsman 580.752080 Operator's Manual

FoJJow t hese in_rucflons to changeProjectPro
T M
nozzJes:
1. PulI back collar on quick-connect and pulI current
ProjectPro
TM
nozzle off. Store ProjectPro
TM
nozzlesin
holder provided on the accessorytray.
WARNING
The high pressure stream of water that this
_ quipment produces can cut through skin and its
underiying tissues, ieading to serious injury and
)ossible amputation.
* NEVER exchange ProjectPro
T M
nozzles without lockingthe
trigger lock on the spraygun.
o DONOT twist ProjectPro
T M
nozzles whilespraying.
.
Select desired ProjectPro
TM
nozzte:
o Fordelicate rinse (iower pressure and higher flow),
for gentte cteaning of cars/trucks, boats, RV's, patio
furniture, iawn equipment, etc. select yellow
delicate ProjectPro
TM
nozzle.
Forgeneralrinsing (medium pressureand medium
flow), idealfor most aii purposecieaningsuch as
home siding, brick patios,wood decks, drivewaysand
sidewalks,garagefloors, etc. selectorangegeneral
ProjectPro
TM
nozzle.
For maximum rinsing (higiler pressure and lower
flow), for stubborn or hard to reachsurface such as
second story surfaces, paint removal, oii stains, rust
removal or other stubborn substances (tar, gum,
grease, wax, etc.), select red max ProjectPro
TM
nozzle.
3. Puff back on coflar, insert seiected ProjectPro
TM
nozzle
and releasecollar. Tug on ProjectPro
TM
nozzleto make
sure it is secureiy in piace.
4. For most effectivecleaning, keep ProjectPro
TM
nozzlefrom
8 to 24 inches away from cleaningsurface, if you get the
nozzietoo close, you may damagethe cleaningsurface.
5. DONOTget closerthan 6 incheswhen cleaningtires.
Hew te Use the HydreFeam
TM
Launcher
The quick-connect on the nozzleextension aliows you to
attach the HydroFoam
TM
iauncher. Usethe HydroFoam
TM
launcher to appiy HydroFoam
TM
wash or other project specific
cteaners to help break down stubborn dirt and grime on a
variety of surfaces.
Follow these indmctions to attach the I.iydreFearn
T M
launcher:
1. PuiI back collar on quick-connect and pull current
ProjectPro
TM
nozzle off. Store ProjectPro
TM
nozzles in
hoider provided on the accessopJtray.
2. Puff back on coliar, insert HyrdoFoam
TM
iauncher and
releasecoiiar. Tug on HyrdoFoam
TM
iauncher to make
sure it is securely in place.
iMPORTANT:Also see the HydroFoam
TM
launcher and wash
instruction sheet for important instructions and uses.
Cleaning and Applying Detergent
A, CAUTJO
Chemicalscan cause bodily injupj, and/or property damage.
_ EVER usecausticliquid with pressurewasher.
UseONLYpressure washersafedetergents/soaps. Followall
manufacturers instructions.
14