Maintenance; Recommended Accessories - Craftsman 113.213843 Owner's Manual

maintenance
WARNING: For your own safety, turn switch "OFF"
and remove plug from power source outlet before
maintaining or lubricating your drill press.
Frequently blow out any dust that may accumulate in-
side the motor.
A coat of automobile-type wax applied to the table and
column will help to keep the surfaces clean.
WARNING: To avoid shock or fire hazard, if the
power cord is worn or cut, or damaged in any way,
have it replaced immediately.
lubrication
All of the BALL BEARINGS are packed with grease at
the factory. They require no further lubrication.
Periodically lubricate the gear and rack table elevation
mechanism, the SPLINES (grooves) in the spindle, and
the RACK (teeth of the quill). See "Getting to Know
Your Drill Press" - p. !4 for diagram.
recommended accessories
WARNING: Use only recommended accessories.
Follow instructions that accompany accessories.
Use of improper accessories may cause hazards.
Drill Bits ......................... See Catalog
Hold-Down and Guide .................. 9-2457
Drill Press Vises ................... See Catalog
Rotary Table .......................... 9-2495
Drill Press Mortising Kit ................ 9-29503
Hole Saw up to 2 1/2" dia. max ....... See Catalog
5 Pc. Stop Collar Set .................. 9-67063
Sanding Drums ................. 9-2497- 9-2498
Buffing Wheels up to 4" dia. max ...... See Catalog
Polishing Wheel, ! 1/2" x 1". ............ 9-64991
Power Toot Know-How Handbooks
Radial Saw ....................... 9-2917
Table Saw ........................ 9-2918
]-he recommended accessories listed here
are current and were available at the time
this manual was printed.
21