Unpackthe Pressure Washer; Carton Contents - Craftsman 580.752140 Operator's Manual

Your cleaning system requires some assembIy and is ready
for use only after it has been properiy serviced with the
recommended oil and fuel.
tf you have any prohbms with the assembly of your
pressurewasher, please call the pressurewasher hempline
at 1o800o222o3136.
UNPACKTHE PRESSURE WASHER
1. Remove eveGrthingfrom carton except pressure washer.
2. Open carton completely by cutting each corner from top
to bottom.
3. Remove pressure washer from carton.
CARTONCONTENTS
Checkali contents, if any parts are missing or damaged, call
the pressure washer hetpline at 1=800=222=3136.
° Main Unit
* Handb with 6ieaning Tank Assembly
o Accessory Tray
° High Pressure Hose
* Spray Gun
o NozzleExtensionwith Quick Connect Fitting
, HydroFoam
TM
Wash
° Oil Bottle
, Parts Bag (which includes the following):
o Operator's Manual
, Owner's Registration Card
, Safety Goggies
o DetergentSiphoning Hose/Fiiter
, Bagcontaining 3 muiti-coiored ProjectPro
TM
NozzIes
, HydroFoam
TM
Launcher
o HydroFoam
TM
Launcher & Wash instruction Sheet
° FreshStart Fuel Cartridge
* HandleFasteningHardwareKit (which includes):
* Carriage Bolts (2)
° Plastic Knobs (2)
° Tree Clips (4)
Becomefamiiiar with each piece before assembling the
pressure washer. Identify ati contents with the iiiustration on
page 6. if any parts are missing or damaged, call the
pressure washer hetpline at 1=800=222=3136.
ASSEMBLING CLEANING SYSTEM
YourCraftsman cleaning system will need assembly before
operation:
1. Fiii out and send in registration card.
2. Attach handle and accessory tray.
3. Connect detergent siphon hose to pump.
4. Add oii to engine crankcase.
5. Add fuel to fuel tank.
6. Connect pressure hose to spray gun and pump.
7. Connectwater supply to pump.
8. Attach nozzleextension to spray gun.
9. Select/attach quick connect ProjectPro
TM
nozzleto nozzle
extension.
Attach Handle and Aecesse_ Tray
1. Placehandle (A) onto handb supports (B) connected to
main unit. Make sure holes (C) in handb align with holes
(C) on handle supports.
NOTE:It may be necessary to move the handle supports
from side to side in order to align the handie so it wiii slide
over the handb supports.
2. Insert carriage boits (A) through holes from outside of
unit and attach a plastic knob (B) from inside of unit.
Tighten by hand.
3. Placeaccessory tray (A) over holes (C) on handle
(viewing from front of unit). Push the tree clips (B) into
the holes until they sit fiat against the accessory tray.
/
/
Insert multi-colored ProjectPro
TM
nozzlesand other
supplied accessories in spaces provided in accessory
tray. See How to Use Accessory Tray.