Craftsman 580.752140 Operator's Manual page 14

.
Select desired ProjectPro
TM
nozzle:
* Fordelicate rinse (lower pressure and higher flow),
for gentb cleaning of cars/trucks, boats, RV's, patio
furniture, lawn equipment, etc, select yellow
delicate ProjectPro
TM
nozzle.
Forgeneralrinsing (medium pressureand medium
flow), idealfor most atI purposecleaningsuch as
home siding, brick patios,wood decks, drivewaysand
sidewalks,garagefloors, etc., selectorangegeneral
ProjectPro
TM
nozzle.
For maximum rinsing (higher pressure and lower
flow), for stubborn or hard to reach surface such as
second story surfaces, paint removal, oii stains, rust
removal or other stubborn substances (tar, gum,
grease, wax, etc.), select red max ProjectPro
TM
nozzle.
4. PulI back on collar, insert selected ProjectPro
TM
nozzle
and releasecollar. Tug on ProjectPro
TM
nozzleto make
sure it is securely in place.
5. For most effectivecleaning, keep ProjectPro
TM
nozzlefrom
8 to 24 inches away from cleaningsurface. If you get the
nozzletoo close, you may damagethe cleaningsurface.
6. DONOTget closerthan 6 incheswhen cleaningtires.
Hew te Use the HydroFoam
TM
Launcher
The quick-connect on the nozzleextension aliows you to
attach the HydroFoam
TM
launcher. Usethe HydroFoam
TM
launcher to appiy HydroFoam
TM
wash or other project specific
cleaners to heip break down stubborn dirt and grime on a
variety of surfaces.
FeJJew t hese instrustbns te attach the HydrePaam
TM
launcher:
1. Engagetrigger iock on spray gun.
2. Puli back collar on quick-connect and puli current
ProjectPro
TM
nozzle off. Store ProjectPro
TM
nozzles in
holder provided on the accessory tray.
3. PulI back on collar, insert HyrdoFoam
TM
launcher and
releasecollar. Tug on HyrdoFoam
TM
launcher to make
sure it is securely in place.
IMPORTANT:Also see the HydroFoam
TM
launcher and wash
instruction sheet for important instructions and uses.
Cteanin9 and Applyin9 Detergent
NEVER usecausticliquid with pressurewasher.
UseONLYpressure washersafedetergents/soaps. Followall
rnanufacturers i nstructions.
Te apply detergent felbw these steps:
1. Attach one of the detergent siphon hoses following
instructions Attach Detergent Siphon Hose to Pump.
IMPORTANT:Be sure engine is off and allowed to cool before
switching detergent siphoning hoses.
WARNING
Contact with muffler area can result in serious
burns.
Exhaustheat/gases can ignite combustibles,
structures or damage fuel tank causing a fire.
• DONOT touch hot partsand AVOID hot exhaustgases.
° Allowequipment t o cool beforetouching.
2. Review ProjectPro
TM
nozzle and HydroFoam
TM
launcher
use.
3. PrepareHydroFoam
TM
wash according to instructions on
the bottie or prepare detergent solution as required by job.
14