Advertisement
_t,
WARNING: Always wear safety goggles or safety
glasses with side shields when operating tools. Fail-
ure to do so could result in objects being thrown into
your eyes, resulting in possible serious injury.
DRILLING
See Figure 11.
A level is located on top of the motor housing to help keep
the drill bit level during use.
• Check the direction of rotation selector for the correct
setting (forward or reverse).
• Secure the material to be drilled in a vise or with
clamps to keep it from turning as the drill bit rotates.
•
Hold the drill firmly and place the bit at the point to be
drilled.
• Depress the switch trigger to start the drill.
• Move the drill bit into the workpiece, applying only
enough pressure to keep the bit cutting. Do not force
the drill or apply side pressure to elongate a hole. Let
the tool do the work.
_"
WARNING: Be prepared for binding at bit break-
through. When these situations occur, drill has a
tendency to grab and kick opposite to the direction
of rotation and could cause loss of control when
breaking through material. If not prepared, this loss
of control can result in possible serious injury.
• When drilling hard, smooth surfaces, use a center
punch to mark the desired hole location. This will pre-
vent the drill bit from slipping off-center as the hole is
started.
• When drilling metals, use a light oil on the drill bit to
keep it from overheating. The oil will prolong the life of
the bit and increase the drilling action.
• If the bit jams in the workpiece or if the drill stalls,
stop the tool immediately. Remove the bit from the
workpiece and determine the reason for jamming.
This drill has an electric brake. When the switch trigger
is released, the chuck stops turning. When the brake is
functioning properly, sparks will be visible through the
vent slots on the housing. This is normal and is the action
of the brake.
LEVEL
Fig. 11
15
Advertisement
