Lights; Adjusting The Lcd Panel Density - Epson Stylus Photo RX500 Basic Operation Manual

Lights

Light
! Error
Mode
(Copy,
Memory Card,
Scan, Setup)
A, B, C, D

Adjusting the LCD panel density

You can adjust the density of the LCD panel as follows.
1. Press the P On button to turn on this product.
2. Press the Setup Mode button to enter the Setup Mode.
3. Press the A or the l/r Select button repeatedly until
button. The LCD panel is shown below.
A
C
Adjust the density of the LCD panel. Press the C button to make
4.
the panel lighter, or the D button to make it darker.
5. When the adjustment is finished, press the OK button.
14
Using the Control Panel
Pattern Status
On An error occurs. (For details, see
"Troubleshooting" on page 84)
On Shows the mode this product is in.
On Indicates the button is valid.
appears on the LCD panel, and then press the x Color
l -
ononon
B
+ r
D