Bbsk Instructions - COZY CDV155B Installation And Operating Instructions Manual

STEP 1)
STEP 2)
STEP 3)
STEP 4)
STEP 5)
STEP 6)
STEP 7)
STEP 8)
STEP 9)
STEP 10)
STEP 11)
OPTIONAL BBSK INSTALLATION INSTRUCTIONS
LOCATE DIMPLE AT RIGHT REAR OF THE CABINET TOP. SEE FIGURE A.
USING DIMPLE AS A LOCATOR, DRILL A V_," HOLE.
STRAIGHTEN THE CAPILLARY TUBE. DO NOT KINK THE CAPILLARY TUBE OR SENSING
BULB. SEE FIGURE B.
FROM TOP OF HEATER, INSTALL SENSING BULB DOWN AND UNDER THE GAS CONTROL
VALVE SO THAT THE CAPILLARY TUBE IS BETWEEN THE BACK OF THE HEATER AND THE
WALL. SLIDE WHITE CABLE CLAMP (PROVIDED) ONTO SENSING BULB AND SECURE TO THE
BOTTOM OF THE GAS VALVE USING THE 10-24X3/8" SCREW PROVIDED.
SECURE THE CONTROL SWITCH (SEE FIGURE B) TO THE RIGHT SIDE OF THE INNER WRAPPER
USING PREPUNCHED HOLES AND TWO #8 SCREWS PROVIDED. SEE FIGURE C. NOTE:
SWITCH MUST BE INSTALLED TO BE OUTSIDE THE WRAPPER.
RUN THE TWO CONTROL WIRES FROM THE SWITCH DOWN THE RIGHT OUTSIDE OF WRAP-
PER. CONNECT ONE WIRE TO THE "TH" TERMINAL AND ONE TO THE "THPP" TERMINAL ON
THE GAS VALVE. SEE FIGURE D. SLIDE A WHITE CABLE CLAMP (PROVIDED) OVER BOTH
WIRES AND SECURE TO WRAPPER USING SCREW THAT SECURES THE FLOOR SHIELD.
IF HEATER IS NOT INSTALLED TO WALL, FOLLOW INSTRUCTIONS TO DO SO.
REMOVE AND DISCARD THE LIGHTING INSTRUCTIONS SUPPLIED WITH HEATER. REPLACE
WITH LIGHTING INSTRUCTION SUPPLIED IN BBSK KIT.
PLACE CABINET ONTO HEATER, THE CONTROL ROD SHOULD EXTEND UP THROUGH THE V__"
HOLE IN TOP OF CABINET.
PLACE THE CONTROL KNOB ONTO THE CONTROL ROD AND SECURE BY PUSHING DOWN.
FOLLOW THE LIGHTING INSTRUCTIONS TO PLACE THE HEATER IN OPERATION.
1316"_
f
tZZZZZZZZZD
CDV15
FIGURE A
I
3-1,4"
__2
\
DIMPLE
-6-12'
_
_4
, r _ _ DIMPL]
E===3 _----
cxxx=:n _-----_ _
CDV25/33
Control
l J_ _ _._-= - LTnit
Sensing _,
Bulb
FIGURE B
RIGHT SIDE OF%
IN_ER WRAPPER'I\
t '
[ /'_.
I / \+ i
\ ,\,y/! +
CDV15 ' /
FIGURE C
RIGHT SIDE OF -i l
INLNER WRAPPER X_
1-7/_" '_
_<-- 2"+
[ . ............
,
CDV25/33',,//
J
-TH__p ,¸
FIGURE D
Page 12