Adjustments - COMPANION 315.241940 Operator's Manual

NOTE: Many oftheillustrations inthismanual show only
portions o fyour c ompound miter sew, Thisisintentions]
sothatwecanciearlyshow p oints being made inthe
Il-
lustrations. Never operate your Raw without all guard==
securaJy in place end in good operating condition.
SQUARING THE MITER TABLE TO THE
FENCE
See Figures 13- 16.
• Unplug your saw.
• Push down on the sew arm and pu[I out the lock pin to
release t he saw arm.
• Raise saw arm to its fult raised position.
• Loosen the miter lock levers.
• Rotate the miter table untTI t he pointer is positioned
atO'.
• Securelytighten the miter lock levers.
• Lay a framing square fiat on the miter table. Place one
tag of the square against the fence. Pla.cethe other
(eg of the square beside the throat plate in the miter
table. The edge of the square and the slot in the throat
plats in the miter table shouldbe parallelas shown in
figure 13.
• If the edge of the framing square and the throat plate
in the miter tabfe are not paraliefas shown in figures 14
and 15, adjustments are needed.
• Using the blade wrench, loosen the socket head
screws securingthe fence. Adjust the fence left or right
untilthe h'amlngsquare and throat plate are paraReL
• Retighten the screws securelyand recheck the fence-
to-table alignment,
FRAMING
SQUARE FENCE MITERTABLE
FRAMING FENCE
SQUARE / MITER TABLE
THROAT PLATE
VIEWOFMITER TABLE NOTSQUARE WITH
FENCE, ADJUSTMENTS AREREQUIRED
F_g.f 4-
FRAMING
SOUARE
FENCE
THROAT PLATE
VIEWOFMITER TABLE NOTSQUARE WITH
FENCE, A DJUSTMENTS A REREQUIRED
Fig. 15
SOCKET HEAD SOCKFT HEAD
SCREW(S) SCREW(S)
THROAT PLATE
VIEWOFMITER TABLE SQUARE WITHFENCE
CORRECTLY ADJUSTED
Fig. 13
Fig. 16
17