Clamping Wide Workpieces - COMPANION 315.241940 Operator's Manual

Bevel
Angle Typeo#
Cut
Setth_g
side, inside comer
1. Top edge.of molding against fence
33.85" 2. Miter table set fight 31.62"
3. Save left end of cut
Right side, Irmlde comer
1. Bottom edge of molding against fence
33.85" 2. Miter table set left 31.62"
3. Save (eft end of cut
Left side, outside corner
_. Bottom edge of motding against fence
33.85" 2. Miter tsble set left 31.62"
3. Save right end of cut
Right aide, outside comer
1. Top edge of molding against fence
33.65" 2. Miter table set right 31.62"
3. Save right end of cut
CUTIBNG WARPED MATERIAL
See Figures32 - 34.
When cutting warped material, always make sure it is
positionedon the miter table with the convex side against
the fence as shown in figure 32.
If the warped material _spositionedthe wrong way as
shown in figure 33, it will pinch the blade near the comple-
tion of the out.
RIGHT
Fig. 32
WRONG
Fig.33
_, WARNING: To avoid a kickback and to avoid
seriouspersona_ injury,never positionthe concave
edge of bowed or warped marsala[ against the fence.
CLAMPING WIDE WORKPIECES
8ee Figure 34.
When cutting wide workpiecas such as a 2 in, x 6 in.,
boards should be clamped with a C-clamp as shown in
figure 34.
Fig. 34
26