COMPANION 315.241940 Operator's Manual page 13

The following i tems areincluded w ithyour C ompound Miter S aw:
• Saw Blade - 10 ln, • Blade Wrench
• Work C_amp • Operator's Manual
SAWBLADE
=,= _ BLADE WRENCH
WnRKCLAMP
Fig. 7
,I_ WARNING: The use of atfachments or accessoriesnot listed might be hazardous and could cause ssdous
personalinjury.
UNPACKING
This product has been shipped completely assambled.
• Carefully lift saw from the carton by the carryinghandle
and the saw base, and place it on a level work surface,
NOT _" This saw is heavy.To avoid back iniury,liftwith
your legs, not your back, and get help when needed.
• Yoursaw has been shipped with the saw arm secured
in t_s down position.To release the saw arm, push
down on the top of the saw arm, cut the tie-wrap, and
pull out on the lock pin.
• Lift the saw arm by the handle. Hand pressureshould
remain on the saw arm to prevent sudden rise upon
rslsasa of L_etie wrap.
• Inspect the tool carefuffyto make sure no breakage or
damage occurred duringshipping.
• Do not discardthe packing material until you have
carefullyinspected and satlsfactodiyoperated tha tool
• The _w is factory set for accurate cutting.After
assemblingit, checkfor accuracy, ff shippinghas
inSusncedthe settings, refer to spsciflcprocedures
explained in this manual
• Ifanypartsaredamaged or missing, please call
1-800-932-3188 for assistance.
J_l WARNING= If any parts are missing,do not operate
this toot until the missing parts are replaced. Failure
to do so could result in possibleserious personal
inlury.
13