Craftsman evolv 320.17263 Operator's Manual page 6

tool will do the job better and more safely at the rate for which is designed.
Do not use tool if the switch does not turn it on or off. Any tool that
cannot be controlled with the switch is dangerous and must be repaired.
Disconnect the plug from the power source before making any
adjustments, changing accessories, or storing the tool. Such preventive
safety measures reduce the risk of starting the tool accidentally.
Store idle tools out of reach of children and other untrained persons.
Tools are dangerous in the hands of untrained users.
Maintain tools with care. Keep cutting tools sharp and clean. Properly
maintained tools, with sharp cutting edges are less likely to bind and are
easier to control.
Check for misalignment or binding of moving parts, breakage of parts,
and any other condition that may affect the tools operation. If damaged,
have the tool serviced before using. Many accidents are caused by poorly
maintained tools.
• Use only accessories that are recommended by the manufacturer for
your model. Accessories that may be suitable for one tool, may become
hazardous when used on another tool.
• Do not alter or misuse tool. These tools are precision built. Any alteration or
modification not specified is misuse and may result in a dangerous condition.
SERVICE
• Tool service must be performed only by qualified repair personnel.
Service or maintenance performed by unqualified personnel could result in a
risk of injury.
When servicing a tool, use only identical replacement parts. Follow
instructions in the Maintenance section of this manual. Use of
unauthorized parts or failure to follow Maintenance instructions may create a
risk of shock or injury.
SAFETY SYMBOLS FOR YOUR TOOL
The label on your tool may include the following symbols.
V ............................................................... Volts
A ............................................................... Amps
Hz ............................................................. Hertz
W .............................................................. Watts
min ........................................................... Minutes
'_J ........................................................... Alternating Current
---. ......................................................... Direct Current
n............................................................ No-load Speed
17263Manual Revised 09-0709 Page 6