Craftsman evolv 320.17263 Operator's Manual page 12

or rotation with hammering
action.
1. For rotation only, push
the switch to the side of the
hammer drill with the mark.
2. For rotation with hammering
action, push the switch to the
side with the mark.
DEPTH GAUGE (Fig.6)
1. The adjustable depth gauge
is used to control the depth of
drilled holes.
2. Install the depth gauge as
shown in the Assembly section.
3. Loosen the auxiliary handle
to facilitate the adjustment of
the depth gauge.
4. Adjust the depth gauge so
the drill bit extends beyond the
depth gauge end to the desired
drilling depth.
_, WARNING: Failure to
unplug the hammer drill when
Fig. 5 hammer/drill selection switch
Fig. 6
3
depth gauge
drill bit
auxiliary handle-_
changing bits or accessories could result in accidental starting and cause
serious injury.
INSTALLING AND REMOVING THE DRILL BIT (FIG. 7)
To install
1.
2.
3.
Unplug the hammer drill.
Insert the bit by placing it
into the chuck as far as it
will go.
Hand-tighten the chuck
by successively inserting
the chuck key into one of
the three guide holes and
turning it clockwise until all
jaws are tighten against the
bit.
Fig. 7
bit
guide chuck
holes
4. Remove the chuck key.
17263 Manual Revised 09-0709 Page 12