Craftsman evolv 320.17263 Operator's Manual page 7

[] .............................................................. Class II construction
.../min ....................................................... Revolutions or Strokes per minute
&
• k, ........................................................... Indicates danger, warning caution.
It means attention! Your safety is
involved.
SPECIFIC SAFETY RULES FOR HAMMER DRILL
Hold the tool by its insulated gripping surfaces when performing an
operation where the cutting tool may contact hidden wiring. Contact with
a "live" wire will make exposed metal parts of the tool "live" and shock the
operator.
Never leave the trigger locked "ON",before plugging the tool in ,check that
the trigger lock is "OFF".
Do not use the "Lock-ON" feature in situations where drill bit binding is
likely.
Position the cord clear of rotating bit.
The hammer drill bit may be very hot. Do not touch the drill bit immediately
after drilling or hamming. The hot bit can cause a severe burn.
Secure the material being drilled. When drilling sheet metal, use a vice
and a block of wood placed under the material. Never hold the metal in your
hand, across your hand, or across your legs. Rotating sheet metal can cause
serious injury.
Never leave keys and adjusting wrenches on the tool before turning the
tool on.
• Do not use dull or damaged bits and accessories.
• When installing a drill bit, insert the shank of the bit well within the jaws of
the chuck.
• If the tool is stalled, release the trigger immediately, reverse the direction of
rotation, and slowly squeeze trigger to back out the bit.
• Do not operate the power unit with a damaged cord or plug. If damaged,
the plug should be replaced immediately.
• Do not operate power unit if it has received a sharp blow, been dropped,
or otherwise damaged in any way; take it to a qualified service person.
• Disconnect the power unit from power supply when it is not in use.
Following this rule will reduce the risk of electric shock, fire, or serious
personal injury.
_, WARNING: To reduce the risk of injury, user must read instruction manual.
,_ WARNING: Do not force the power tool. In heaw-duty applications,
excessive force can cause the power tool to overheat.
17263Manual Revised 09-0709 Page 7