Procedure - Fujitsu PRIMERGY TX300 S6 Options Manual

2

Procedure

V
CAUTION!
The actions described in this manual shall be performed by technical
specialists. A technical specialist is a person who is trained to install
the server including hardware and software.
Repairs to the device that do not relate to CSS failures shall be
performed by service personnel. Please note that unauthorized
interference with the system will void the warranty and exempt the
manufacturer from all liability.
Any failure to observe the guidelines in this manual, and any improper
repairs could expose the user to risks (electric shock, energy
hazards, fire hazards) or damage the equipment.
Ê First of all, carefully read the safety instructions in the chapter
instructions" on page
Ê Make sure that all necessary manuals (see the section
overview" on page
importantly, you will need the Operating Manual for the server and the
Technical Manual for the system board.
Ê Shut the server down correctly, switch it off, disconnect the power cords and
open the server as described in the chapter
page 27.
Ê Carry out the expansion or upgrade of your server as described in the
pertinent chapter.
I
Installation and removal of the hot-plug components are described in
the Operating Manual.
Ê Close the server, connect it to the power outlet, and switch it on as described
in the chapter
Ê Start the operating system and make the appropriate configuration if
necessary (see the Operating Manual).
I
For the latest information on optional products provided for the
TX300 S6 see the configurator of this server:
https://sp.ts.fujitsu.com/dmsp/docs/cnfgtx300s6.pdf
TX300 S6
19.
12) are available; print the PDF files if required. Most
chapter "Completion" on page
Options Guide
"Documentation
chapter "Preparation" on
105.
"Safety
17