Fujitsu PRIMERGY TX300 S6 Options Manual page 78

Installing expansion cards
Figure 50: Installing an expansion card
Ê Carefully press the new expansion card into the relevant slot on the system
board (1).
Ê Fit the clip onto the slot cover so that the pin fits into the hole.
Ê Push the clip under the metal nose (2) until it clicks into place.
Ê Swing the lever (3) downward into its locking position.
Ê If required, connect the cables to the expansion card and other components.
Ê Close the server, connect it to the power outlet, and switch it on as described
in the chapter "Completion" on page
78
105.
Options Guide
Expansion cards and BBU
TX300 S6