National Instruments GPIB GPIB-ENET/100 Getting Started Manual page 58

Index
NI-488 Config
changing NI-488.2 settings, 4-1
example (figure), 4-2
locating and starting, 4-1
proper Ethernet settings, B-1
running before connecting GPIB
devices, 2-4
NI-488.2
components, 1-4
function information, 6-6
IBIC 488.2 utility, 6-6
installing, 2-1
interfaces supported by this version, B-2
language interfaces, B-5
overview, 1-4
programming considerations, 6-6
viewing or changing configuration, 4-1
NI-488.2 Test
accessing, 5-1
if error messages displayed, 5-1
if failure, B-2
running before connecting GPIB
devices, 2-4
verifying software installation, 5-1
O
optional equipment
hardware, 1-2
multiple-computer software license, 1-2
overview
features, 1-3
GPIB-ENET/100, 1-2
LEDs, 1-3
NI-488.2, 1-4
GPIB-ENET/100 for Mac OS
P
physical characteristics, C-1
power connection
installing (figure), 2-4
location, 2-3
power cord
installing, 2-3
types, 1-1
power requirements, C-1
powering on your GPIB-ENET/100, 2-4
programming considerations, 6-6
properties
configured device (figure), 3-5
configuring, 3-4
unconfigured device (figure), 3-4
PWR/RDY LED
description, 1-4
if blinking a pattern, 2-5, A-1
if flashing rapidly, 2-5, 3-1, A-1, B-1
if red, 2-5
if yellow, 2-5, A-1
interpreting status messages, A-1
observing during self tests, 2-5
overview, A-1
when using CFG RESET switch, 6-3, 6-4
R
rear panel (figure), 2-3
rebooting
after Ethernet configuration, 3-6
after firmware update, 6-4
Refresh
discovering new devices on subnet, 3-3
updating list of Ethernet devices, 3-3
verifying hostname, 3-9
related documentation, xii
requirements, 1-1
I-4 ni.com