National Instruments GPIB GPIB-ENET/100 Getting Started Manual page 56

Index
E
electrical characteristics, C-1
environmental characteristics, C-1
error checking, B-5
error code, A-1
Ethernet address, 2-2
Ethernet connection
location, 2-3
Ethernet Device Configuration utility
! shown on device listing, 3-8
accessing during normal operation, 6-3
busy device, 3-3, B-3, B-5
example (figure), 3-2
GPIB-ENET, B-4
if GPIB-ENET/100 is not listed, B-4
locating and starting, 3-2
network configuration mode, 3-1
Refresh option, 3-3, B-4
unconfigured device, 3-3
verifying hostname, 3-8
viewing settings in normal mode, 3-1
when to use, 2-5, 3-1
Ethernet Device Firmware Update utility
Bad checksum message, B-4
before using, 6-4
example (figure), 6-5
important warning, 6-4
location and starting, 6-5
using, 6-4
when to use, 6-4
Ethernet settings in NI-488 Config, 4-2
F
failed device
reported by PWR/RDY LED, 2-5, A-1
firmware
updating, 6-4
front panel (figure), 1-3
GPIB-ENET/100 for Mac OS
G
gateway IP, 3-6
getting started, 1-1
glossary, G-1
GPIB cable
connecting, 2-4, 5-2
when to install, 5-2
GPIB communication, B-5
GPIB Configuration utility.
See NI-488 Config
GPIB connection
location, 2-3
GPIB-ENET
configuring, B-3
replacing with GPIB-ENET/100, B-3
using with GPIB-ENET/100, B-3
GPIB-ENET/100
front panel (figure), 1-3
hardware overview, 1-2
installing, 2-2
network properties, 3-4
rear panel (figure), 2-3
H
hardware overview, 1-2
hostname
accepting DNS hostname, 3-8
changing DNS entry, 3-8
default hostname, 2-2
editing, 3-8
fixing verification error, 3-8
using to identify device, 6-2
using with NI-488 Config, 4-3
verifying, 3-8
viewing or changing, 3-4
I-2 ni.com