To Turn Off The Remote Start; To Override Vehicle From Remote Start Control; Temporary Stop Feature; Timer Start - Autopage C3-RS-625 Operation Manual

Professional 2-way am/am remote car starter & keyless entry system with two-way serial port data link
Hide thumbs Also See for C3-RS-625:
Table of Contents

Advertisement

vehicle will remote start or remote shut down. (Programming Required)
NOTE: The Remote Start Unit w ill not start the vehicle if any one of the
following conditions exists:
1. The hood is opened.
2. The brake pedal is pressed.
3. The optional remote start enable toggle switch is in the OFF position.
4. The gear selector is in any gear other then "PARK" or "NEUTRAL"

TO TURN OFF THE REMOTE START:

When the engine is running (by remote start), if you want to stop it,
1. Press
button once on the transmitter.
2. Move the optional remote start enable toggle switch to OFF position.
(If installed)
3. Press the brake pedal, the vehicle will shut down and turn off the parking
light to indicate engine stopped.

TO OVERRIDE VEHICLE FROM REMOTE START CONTROL:

To operate the vehicle while it is running from the remote start:
1. Insert the ignition key and turn it to "ON" (not the start) position.
2. Press the brake pedal.
Note: If the brake pedal is pressed before the key is in the ON
position, the engine will shut down.

TEMPORARY STOP FEATURE:

This feature allows the vehicle to remain running after the key has been
removed from the ignition. This feature is useful for occasions when you
wish to exit and lock the vehicle for short periods of time, but would like to
leave the engine running and the climate control on.
1. Before turning off the engine, press the
transmitter. The parking lights will come on and the LED will flash 3
times to confirm Temporary Stop feature 'ON'
2. Turn the ignition key to OFF position. (The engine will stay running.)
3. The engine will run until the pre-programmed time elapsed or shutdown
input is received.
TIMER START: You must fully understand this feature to operate the
remote start safely. Use caution in using this feature.
This unit can be programmed to start and run the engine every 3 hours.
The engine will run for the programmed run time and then shut down.
IMPORTANT: Timer Start should be used only in open areas, NEVER start
and run the vehicle in on enclosed space such as a garage or carport.
Three hours timer start: This feature is design for an extreme cold
climate usage. The system will auto start the vehicle every 3 hours, to
prevent engine freezing and hard to start.
7
button once on the

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xt-43 lcdXt-33

Table of Contents