Table of Contents
Advertisement
Turbo timer mode keeps the engine running after arriving at your destination for a
programmable period of 1, 3 or 5 minutes. This allows the system time to conveniently
cool down the turbo after you have left the vehicle. To activate the turbo timer:
1. While engine is running, place the transmission gear in the park position and pull up
the hand brake.
2. Before turning off the engine, Spin up the
the "Turbo Start" button or press and release
-- The parking light will activate to indicate the remote start has entered turbo timer mode. --
3. Pull out the "Ignition Key" from the key cylinder.
-- The engine will continue to run. --
4. Exit and secure the vehicle.
-- Engine continues running until the pre-programmed time has elapsed. --
If you do not want the vehicle to continue running, simply step on the vehicle's brake, or activate the
button in succession. Any of these will cause the engine to turn off.
E. TIMER START:
Your system has the ability to automatically start the vehicle every 1,2 or 3 hours, run for the
pre-programmed time (10, 20, 30 or 60 minutes), and then shut off. This will continue for 48 hours. This
feature is especially useful in cold climates where the only means to keep the engine and engine fluids
warm is to periodically start the engine.
If the system is set up to start in temperature mode, the system can be programmed to automatically start
the vehicle engine whenever the temperature inside the vehicle reaches or drops below the
preprogrammed temperature level. The system will monitor the air temperature every 3 (2 /1) hour and will
only start the engine during extreme cold temperatures.
WARNING! Be certain that the vehicle is outdoors before using this or any remote vehicle-starting device.
A running engine produces dangerous carbon monoxide fumes, which can be harmful or fatal if prolonged
exposure occurs. DO NOT remote start the vehicle if it is garaged.
Timer Start Operation:
1. Turn the ignition key on then off. Within 15 seconds .....
2-a. For 2-Way Transceiver: Spin up the
and then press the "Timer Start" button. or
2-b. For Regular one-way Transmitter: Press the
with 3 seconds press the
3. The parking lights will flash and the siren will chirp 3 times indicating the timed start mode has been
activated.
Daily Timer Start Operation: The feature is very useful for the driver who wants to run the vehicle
punctually at the same time next morning. Before set-up of the "Daily Timer Start", you should set you time
Engine start time (See the "Daily Start Timer" Setting on page 10)
1. Turn the ignition key ON then OFF. Within 15 seconds .....
2. Spin up the
switch to the page 5 and then press the "Daily start" button.
3. The parking lights will flash and the siren will chirp 6 times indicating the daily timed
start mode is activated.
Cancel the timer start: To cancel the timer start do one of the following:
1. Start the vehicle manually with the use of the ignition key.
2. Remote start the vehicle using your keychain RF transmitter.
G. TEMPERATURE CHECK
You can monitor the present indoor temperature of the passenger compartment
through the OLED screen, before cooling or heating your vehicle.
Spin up the
switch to the page
in-door temperature will be shown on the OLED screen. This reading may be higher
than actual ambient temperature due to the greenhouse effect and is relative only to
the inside vehicle temperature.
H. TO TURN OFF THE REMOTE START:
RST1000 OP REV.A
switch to the page
and
switch to the page 5
button first,
button.
and then press the "Monitor TEMP." button; the
4
18
and then press
5
buttons at the same time.
Jun/22/2009
Advertisement
Table of Contents
